SP336EEY-L产品概述
The SP336E is a monolithic serial multi-transceiver device that contains both RS-232 and RS-485/RS-422 line drivers and receivers. The configuration of the SP336E can be reconfigured into eight operating modes including RS-232 only (4TX/4RX), RS-485/RS-422 only (2TX/2RX) full or half duplex, two RS-232/RS-485 mixed modes. two shutdown modes and a diagnostic loop-back mode. Modes may be selected at any time by changing the logic state of the three MODE pins. The device can implement a dual-mode serial port, mixed mode ports or as an interface signal translator. The Exar charge pumps deliver true RS-232 driver output voltages from a single power supply at either 3.3V or 5V. The SP336E requires only four 0.1μF capacitors for charge pump. A slew rate control pin configures driver outputs for either high data rate or slew-controlled data rates. Slew-controlled outputs minimize problems with reflections and ringing on long or un-terminated cables. All RS-485 receivers or transceivers feature high impedance which allow up to 256 transceivers on a shared bus. When configured in RS-485/RS-422 mode, each driver may be individually enabled or put into tri-state, simplifying use on shared buses or bidirectional communication. All receivers have advanced failsafe protection to prevent oscillation when inputs are un-connected. In RS-232 mode each receiver input has a 5k ohm pull-down to ground. Differential Receivers will default to output logic 1 if inputs are floating, shorted or open but terminated. All driver outputs and receiver inputs are protected against ESD strikes up to ±15,000 volts.
Features:
3.3V or 5V Single Supply Operation
Robust ±15kV ESD Protection (IEC 61000-4-2 Air Gap)
Software Selectable Mode Selection
Up to 4 Drivers, 4 Receivers RS-232/V.28
Up to 2 Drivers, 2 Receivers RS-485/RS-422
Full or Half Duplex Configurations
1/8th Unit Load, up to 256 receivers on bus
Mixed RS-232/RS-485 modes
Pin Programmable Slew Rate for Reduced EMI
RS-485 Advanced Failsafe on Open, Short or Terminated Lines
Diagnostic Loop-Back Function
28 Pin SOIC or TSSOP Packaging